Modular control valve
Modular control valves are normally mounted onto a valve skid with piping at the rear, or underneath, to allow quick changes to be made for maintenance purposes. Piping can, however, be dispensed with almost totally by mounting valves onto a manifold block- with interconnections formed by drilled passages in a solid block or by cut-outs on a plate-formed manifold.
Modular valve assemblies allow piping to be reduced still further. These follow standards laid down by the Comit~ European des Transmission Oleophydrauliques et Pneumatiques and are consequently known as CETOP modular valves.
Modular valves consist of a base plate and a wide variety of modules which may be stacked up on top. At the top of the stack a spool valve or crossover plate is fitted. Quite complicated assemblies can be built up with minimal piping and the ease of a child’s building block model.
- MSC-02-A/B Hydraulic Solenoid Modular Check Valve
- 1045 Carbon Steel
- [Steel] Steel
- MPCV-03-W Hydraulic Pilot Operated Modular Check Valve
- 11.45 LB
- STANDARD PAINT
- MPCV-03-A/B Hydraulic Pilot Operated Modular Check Valve
- 1.9375 in
- 2.1250 in
- MCV-04 Hydraulic Modular Check Valve
- Contact with Slinger
- Cast Iron
- MTCV-02-A/B Hydraulic Modular Check and Throttle Valve
- Unlubricated
- M16 x 2.0
- MSC-03-A/B Hydraulic Solenoid Modular Check Valve
- 3/8 in
- Flanged Bearing
- MPCV-02-A/B Hydraulic Pilot Operated Modular Check Valve
- 2000 psi
- 3/4 in
- MSC Modular Solenoid Check Valve Hydraulic
- No
- Nitrile
- MBRV Modular Reducing Hydraulic Valve
- Maximum of +800
- SAE 660 (C932
- MCT Modular Throttle/Check Hydraulic Valve
- Standard Grease
- No